T119 digital temperature sensor converts physical temperature to digital output,which can better support the temperature control. To meet requests of different customers, there are also multiple types of temperature sensor.
Introduction:
T119 digital temperature sensor converts physical temperature to digital output,which can better support the temperature control. To meet requests of different customers, there are also multiple types of temperature sensor.
Features:
Maxim DS18B20 chip inside, using a highly thermally conductive potting ensures high sensitivity of the temperature sensor and
minimal temperature delay;
- Each pin of the chip is separated by heat-shrink tubing to prevent short circuit. High-quality stainless steel tube, internal potting, water proof, moisture proof and rustproof.
- The temperature sensor supports the "single bus" interface (1-Wire),which reduces the signal interference towards the system. Suitable for on-site temperature measurement in harsh environments.
- The digital temperature sensor has a unique number and temperature acquisition devices identify the corresponding temperature sensor with the number of the sensor;
- The wire is out of pure copper. Cable length can be customized.
Application:
- Refrigeration
- GMP monitoring system
- Telecom room
- Beer production
- Building automation
- Warehouse
- Environmental monitoring
- Process
- Air conditioning
- Incubation
- Aquaculture
- Greenhouse
- Household refrigerato
Specification:
Dimension:
Wire Definition:
Package:
The temperature sensor adopts a stainless steel sheath which is filled with a layer of high thermal insulation insulating silicone grease and a layer of insulating sealing glue, so that the temperature of the sensor changes The response speed is higher. The default length of the outlet cable is 1 meter, and the connector is able to be connected to different types of GPS trackers.
Connector (Please specify extension length when ordering).
Caution:
•When installing, choose an area which temperature is relatively stable.
•When installed in a refrigerator van, the sensor can be installed at a height of one-half the height of the vehicle, which is to ensure the temperature not change drastically due to the activation of the air conditioning system.
•The position of the sensor should be installed away from the position where water is accumulated and space is tight. The measured temperature of this position will be different from the actual one. There are errors and delays in temperature.
•If other types of temperature recording devices on the vehicle, please install them in the same position as the probes of these devices. This can improve the different settings.
•The sensor wiring should avoid the high temperature area (such as engine, tank) and otherlocations of the vehicle. As far as possible, the wiring is synchronous with the original wiring harness, and the wiring should be tied with a tie bar.
